SERVICE PROGRAM MODE
SM 5-3 B064 Series/B140 Series/G126
Service
Tables
Button Selection Entry (B140 Series/B064 Series)
1. Refer to the SP Mode Tables at the end of this section to find the SP that you
want to adjust.
2. Press the Group number on the left side SP Mode window that contains the SP
that you want to adjust.
3. Use the scrolling buttons in the center of the SP mode window to display the
SP number that you want to open, then press that number to expand the list.
4. Use the center touch-panel buttons to scroll to the number and title of the item
that you want to set, and press . The small entry box on the right is activated
and displays the default or the current setting below.
5. To enter a setting
• Press to enter a minus sign. Then use the keypad to enter the appropriate
number. The number you enter will write over the previous setting.
• Press to enter the setting. (If you enter a number that is out of range, the
key press is ignored.)
• When you are prompted to complete the selection, press Yes.
6. If you need to perform a test print, press Copy Window to open the copy
window and select the settings for the test print. Press Start twice, then
press SP Mode (highlighted) in the copy window to return to the SP mode
display.
7. When you are finished, press Exit twice to return to the copy window.
Service Mode Lock/Unlock (B140 Series Only)
At locations where the machine contains sensitive data, the customer engineer
cannot operate the machine until the Administrator turns the service mode lock off.
This function makes sure that work on the machine is always done with the
permission of the Administrator.
NOTE: This function is not used on B064 series
machines.
1. If you cannot go into the SP mode, ask the Administrator to log in with the User
Tool and then set “Service Mode Lock” to OFF. After he or she logs in:
User Tools > System Settings > Administrator Tools > Service Mode Lock >
OFF
• This unlocks the machine and lets you get access to all the SP codes.
• The CE can do servicing on the machine and turn the machine off and on.
It is not necessary to ask the Administrator to log in again each time the
machine is turned on.
2. If you must use the printer bit switches, go into the SP mode and set SP 5169
to “1”.
3. After machine servicing is completed:
• Change SP 5169 from “1” to “0”.
• Turn the machine off and on. Tell the administrator that you completed
servicing the machine.
• The Administrator will then set the “Service Mode Lock” to ON.
Rev. 05/2005
To Next Page
Loading...
Need help?
General
