Fader Bank Section
122
Listing Channels Assigned to a DCA Group
(SPILL DCA)
Using SPILL DCA lets you take input channels and output buses
assigned to a DCA group and temporarily expand them into a
normal bank to list them.
The DCA group you want to list is loaded into an isolated bank.
1. Load the DCA into an isolated bank.
2. Press (two times) the [SEL] button for the DCA you want
to expand.
The input channels or output buses assigned to the selected DCA
are temporarily expanded into the normal bank.
3. Adjust the input channels or output buses assigned to the
DCA.
4. Press the [SEL] button you selected in step 2 to quit the
SPILL DCA mode.
Using Faders to Adjust the Send Level to
AUX (SENDS ON FADER)
Using SENDS ON FADER lets you use faders to adjust the send level
to AUX.
Memo
SENDS ON FADER is applied to all fader banks.
1. On the HOME screen, go to the knob-assign area and tap
<AUX TARGET>.
The SELECT AUX SENDS window appears.
AUX
TARGET
2. In the SELECT AUX SENDS window, select AUX.
3. Press the [SENDS ON FADER] button to turn it on
(ashing).
All fader banks and assignable fader sections change to the SENDS
ON FADER mode, and you can use faders to adjust the send level to
AUX selected in step 2.
4. Use the faders to adjust the send level.
Memo
5 To change the AUX for sending, carry out steps 1 and 2 again.
Memo
5 If an AUX has been assigned to the fader bank, you can change
the destination AUX by pressing the corresponding [SEL] button.
To Next Page
Loading...
Need help?
General
