Overview of Operations
53
Applying Dynamics
1. Access the CH EDIT window.
0“Access the CH EDIT window” (p. 50)
2. Tap the <DYNAMICS 1 tab> or <DYNAMICS 2> tab.
DYNAMICS 1 tab
DYNAMICS 2 tab
3. Tap <TYPE> and select the dynamics type.
4. Tap <DYNAMICS 1 ON> or <DYNAMICS 2 ON> to turn it
on.
5. Carry out operations using the touch display and knob
section.
Applying EQ
1. Access the CH EDIT window.
0“Access the CH EDIT window” (p. 50)
2. Tap the <EQ tab>.
EQ tab
3. Carry out operations using the touch display and knob
section.
Using Faders to Adjust the Send Level to
AUX (SENDS ON FADER)
Using SENDS ON FADER lets you use faders to adjust the send level
to an AUX.
Memo
SENDS ON FADER is applied to all fader banks.
1. On the HOME screen, go to the knob-assign area and tap
<AUX TARGET>.
AUX TARGET
2. On the SELECT AUX SENDS window, select the AUX that
you want to adjust the send levels to.
3. Press the [SENDS ON FADER] button to turn it on
(ashing).
The SENDS ON FADER mode is activated, and you can use faders to
adjust the send level to the AUX selected in step 2.
4. Use the faders to adjust the send level.
To change the AUX you are sending to, carry out steps 1 and 2
again.
Memo
5 If an AUX has been assigned to the fader bank, you can change
the destination AUX by pressing the corresponding [SEL] button.
To Next Page
Loading...
Need help?
General
