46
Overview of Operations
This section describes typical procedures for operating the M-5000.
Fader Bank Section
On the M-5000, operations are carried out using groups of eight
faders. Each set of eight faders is called a “fader bank.”
The M-5000 is provided with three fader banks and the M-5000C
is provided with two fader banks. You can operate the respective
fader banks in an interlinked way or independently, enabling you to
carry out your intended operations instantly.
Layers
Each fader bank has two basic layers (CHANNEL and DCA/BUS) and
three customizable layers (USER 1 through 3) that you can switch
between according to purpose.
Scrolling
Pressing the [SCROLL K] or [SCROLL J] button shifts the channels
accessed by the fader bank in the currently selected layer by eight
channels at a time.
Basic Operations of Fader Bank Section
Changing Layers
1. Press a layer button to switch to the desired layer.
If you pressed the button at a “Normal bank” (p. 48), other normal
banks also change in an interlinked way.
If an isolated bank has been pressed, only that isolated bank is
switched.
Layer button Description
[CHANNEL] This accesses the input-channel layer.
[DCA/BUS]
This accesses the layer of the DCA group
master and the output buses (MAIN,
SUBGROUP, AUX, MIX-MINUS, and MATRIX).
[USER 1]–[USER 3]
These access user-assigned channels.
You can assign up to 64 at a time for each
layer.
Scrolling the Channels
1. Press the [SCROLL K] or [SCROLL J] button to scroll the
channels.
The channels assigned to the fader bank section in the selected
layer are switched in groups of eight.
Memo
If you pressed the button at a “Normal bank” (p. 48), other
normal banks also change in an interlinked way.
Memo
Scrolling by one channel at a time when the [SHIFT] button is
on.
To Next Page
Loading...
Need help?
General
