M-48 Control
215
M-48 Internal Memory
The M-48 saves the current mixer settings in “current memory.” The
M-48 has 16 memory areas for storing current memory.
The following information is saved in memory.
5 Source level/pan settings
5 Source assignments to groups
5 Group mix (volume/pan/reverb send/EQ/solo)
5 Reverb on/o
Backing Up Current Memory
The current memory is saved in the M-48 approximately every
30 seconds. When you want to save the current memory
immediately, press and hold the M-48’s [STORE] button for
approximately 2 seconds.
Working with Memory in Individual M-48
Units
You use the M-48 SETUP window to access and work with memory
in respective M-48 units.
1. Display the M-48 SETUP window.
2. Tap <MEMORY NO.> or <MEMORY NAME>.
A popover for M-48 memory appears.
M-48 memory list This displays the memory saved in the M-48.
RECALL
This recalls the memory selected using the M-48
memory list to current memory.
STORE
This stores current memory in the memory
selected using the M-48 memory list.
A popup for editing the memory name appears.
CLEAR
This deletes the memory selected using the M-48
memory list.
Storing the Mixer Settings of All M-48 Units in
Memory (M-48 MANAGER Window)
You use the M-48 MANAGER window to store in memory the mixer
settings of all M-48 units (except M-48 units for which <MEMORY
SAFE> is turned on).
1. Display the M-48 MANAGER window.
2. Tap <STORE ALL>.
A popover for selecting the memory number appears.
3. Select the memory number where you want to store the
data.
A popup prompting you to conrm the operation is displayed.
4. Tap <OK>.
The mixer settings of all M-48 units (except M-48 units for which
<MEMORY SAFE> is turned on) are stored at the memory number
you selected in step 3.
To Next Page
Loading...
Need help?
General
