Fader Bank Section
126
Setting an Anchor Channel
1. Press the [FUNC] button.
All fader banks and assignable fader sections change to the
Function Selection mode. Selectable functions are shown on the
fader display.
2. Select “SET ANCHOR”. (Press the corresponding [SEL]
button.)
The M-5000 switches to the SET ANCHOR mode.
3. Press the [SEL] button for the fader which you want to set
an anchor to apply a check mark (ASSIGN )).
4. Press the [FUNC] button to exit the Function mode.
To Next Page
Loading...
Need help?
General
