Fader Bank Section
125
3. Press the [SEL] button for the fader whose assignment
you want to change to apply a check mark (ASSIGN )).
MEMO
You can select multiple faders.
If you selected multiple faders in step 3, then in the following
step 4, when you select an input channel or output bus, the
channels or buses are assigned in succession, starting with the
one you select there.
4. Select the input channel or output bus you want to assign
to the fader you selected in step 3, then press the [SEL]
button (TO FDRS).
The selected input channel or output bus is assigned to the fader
selected in step 3.
MEMO
If you selected multiple faders in step 3, then when you select
an input channel or output bus here, the channels or buses are
assigned in succession, starting with this one.
5. Repeat steps 3 and 4.
MEMO
You can assign up to 64 input channels and output buses to
each of USER 1 through 3 layers.
6. Press the [FUNC] button to exit the Function mode.
Canceling Channel Assignments to Faders
This cancels assignments to the [USER 1] through [USER 3] layers
and to assignable faders.
1. Press the [FUNC] button.
All fader banks and assignable fader sections change to the
Function Selection mode. Selectable functions are shown on the
fader display.
2. Select “UNASSIGN FADER”. (Press the corresponding [SEL]
button.)
“UNASSIGN FADER” appears when you select the [USER 1] - [USER 3]
layers or assignable faders.
The M-5000 switches to the UNASSIGN FADER mode.
3. Press the [SEL] button for the fader whose assignment
you want to release to apply a check mark (UNASSIGN )).
The channel assignment to the fader is cleared.
4. Press the [FUNC] button to exit the Function mode.
To Next Page
Loading...
Need help?
General
