Scene Memory
177
Mixer Parameters Stored in Scenes
The following parameters are stored in scenes.
5 Input patchbay
5 Output patchbay
5 Preamp settings (including input/output units)
5 INPUT CHANNEL
5 MAIN
5 MIX-MINUS
5 SUBGROUP
5 AUX
5 MATRIX
5 Eects
5 GEQ
5 External-device insertion
5 DCA group/MUTE group
5 USB memory recorder
The following parameters are not stored in a scene:
5 MIXER CONFIGURATION
5 DYN POSITION (the sequence of Dynamics and 4-BAND EQ)
5 [TALK 1]-[TALK 3] button on/o settings
5 TALKBACK MIC settings
5 Monitor settings
5 [SOLO] button on/o settings
5 USB memory recorder status (REC/PLAY, etc.)
5 USB memory recorder playback mode
5 USB memory recorder song selection
Recalling a Scene Stored Before Changing the
MIXER CONFIGURATION
One of the most powerful features of this unit is how it lets you
freely set the inputs and outputs for the mixing engine any way you
like.
After changing the MIXER CONFIGURATION, if you recall a scene
stored before the MIXER CONFIGURATION was changed, the unit
operates as follows.
Modication of MIXER
CONFIGURATION (Selection
of TEMPLATE)
Result of scene recall
ARRANGE CHANNEL
The scene reects changing MIXER
CONFIGURATION and is recalled normally
DELETE
STEREO0MONO
MONO0STEREO
The scene stored before changing the
MIXER CONFIGURATION is recalled on the
STEREO L side.
Only parameters existing on the R side
(PATCH R, INSERT R, and so on) remain
unchanged when a scene is recalled.
ADD
Added channels remain unchanged when
a scene is recalled.
Loading MIXER SETTINGS
and SCENE from a project
le
The mixer conguration and scene saved
in the project le can be used normally.
Loading MIXER SETTINGS
from a project le
(Not loading SCENE)
If the channel saved in the scene match
with the mixer conguration saved in the
project, the scene can be used normally.
Scene Section of the Top Panel
[DISP] button
[STORE] button
[SELECT H]/
[SELECT I] button
[NEW] button
[RECALL] button
Name Description
[DISP] button This displays the SCENE window.
[NEW] button
This creates a new scene after the selected scene,
and saves the current mixer parameters.
[SELECT H] button
This selects the scene just before the currently
selected scene.
0“OPTION Window” (p. 240)
[SELECT I] button
This selects the scene just after the currently
selected scene.
0“OPTION Window” (p. 240)
[STORE] button
This stores the current mixer parameters to the
selected scene.
[RECALL] button
This recalls the mixer parameters from the selected
scene.
Creating New Scenes and Adding Scenes
This adds a new scene following the currently selected scene.
1. Go to the scene section on the top panel and press the
[NEW] button.
A popup for setting the scene name is displayed.
M-48 MEMORY
CANCEL This cancels the operation and exits the popup.
M-48 MEMORY This selects the M-48 memory.
M-48 MEMORY
STORE
When this is on, creating a new scene saves all
M-48 mixer settings to the memory number
selected using <M-48 MEMORY>.
2. Specify the scene name, then press the [NEW] button.
A new scene is add immediately following the currently selected
scene.
To Next Page
Loading...
Need help?
General
