About Eect Types
154
DD-3 x2 (Digital Delay)
This is a delay modeled on the Boss DD-3 Digital Delay.
The original has mono in and mono out (or delay/direct out)
specications, but the modeling has dual mono specications that
simulate two units in parallel.
The operation procedures for A and B are the same.
EFFECT ON Turns the eect sound on/o
DIRECT ON Turns the unprocessed sound on/o
MODE
S.50ms: Delay time of 12.5 ms to 50 ms
M.200ms: Delay time of 50 ms to 200 ms
L.800ms: Delay time of 200 ms to 800 ms
HOLD: Hold eect
When <ON> is on, the last sound will take on the
Hold eect. The <D.TIME> adjust the hold time.
When you change the <D.TIME> while the
hold sound is heard, its pitch changes; turn it
clockwise lowers the pitch and counter-clockwise
raises it.
E.LEVEL Level of delay sound
F.BACK Repetition of delay sound
D.TIME
Fine-tuning of delay time
Continuously variable from x0.25 to x1 of range
setting
DM-3 x2 (Delay)
This is a delay modeled on the Boss DM-3 Delay.
The original has mono in and mono out (or delay/direct out)
specications, but the modeling has dual mono specications that
simulate two units in parallel.
The operation procedures for A and B are the same.
EFFECT ON Turns the eect sound on/o
DIRECT ON Turns the unprocessed sound on/o
RPT RATE Adjusts the delay time
ECHO Level of delay sound
INTENSITY Repetition of delay sound
DIST x2 (Distortion/Overdrive)
This is distortion/overdrive that has dual mono specications with
noise suppressor.
<MODE A>/<MODE B> enables use as either distortion or overdrive.
The operation procedures for A and B are the same.
EFFECT ON Turns the eect sound on/o
MODE Used as DISTORTION/OVERDRIVE
LEVEL Level of eect sound
TONE Adjusts tone
GAIN Adjusts amount of distortion
NS THR Adjust the threshold level of the noise suppressor
NS DECAY
Adjusts the decay time when the input level for
the noise suppressor falls below the threshold
level
To Next Page
Loading...
Need help?
General
