– If the pressure is too great, roof seal -1- can be pushed to‐
gether by rolling with roller - 3356- all round.
1.9 Removing and installing panel seal
– Removing glass panel for sunroof ⇒ page 180 .
– Pull seal -1- off sliding/tilting sunroof glass panel -2-.
– Fit new seal -1- to rear edge of panel, start in middle and push
onto sliding/tilting sunroof glass panel -2- from bottom to top.
Note
♦
To ease fitting of seal, coat panel edge with a soapy solution.
♦
If the seal is not correctly installed, the surface will ripple.
♦
The panel seal must be shortened to suit the panel circumfer‐
ence.
– Install sliding/tilting sunroof glass panel ⇒ page 181 .
– Adjust panel seal ⇒ page 182 .
1.10 Removing and installing wind deflector
1.10.1 Removing
– Fully open sliding/tilting sunroof glass panel.
– Push wind deflector and height limit stop out at front of roof
aperture and set wind deflector to vertical position.
Passat 2011 ➤ , Passat Variant 2011 ➤
General body repairs, exterior - Edition 06.2019
1. Sliding/tilting sunroof with glass panel (Meritor) 183
To Next Page
Loading...
Need help?
General
