• The sliding/tilting sunroof glass panel drive is in "0" position, if
a white dot can be seen in the drive aperture -arrow-.
1.14 Removing and installing sliding/tilting
sunroof glass panel automatic preselec‐
tion switch
– Remove preselector for sliding/tilting sunroof roof glass panel
⇒ Electrical system; Rep. gr. 96 ; Lights and switches in roof
trim; Front interior lights .
1.15 Checking parallel running
– Removing glass panel for sunroof ⇒ page 180 .
The mark -arrow- on the rear of the guide upper section -1- must,
on both sides, lie within the marks dimension -a- on the guide
plate -2-.
The guide plate -2- must be located in the guide rails (cannot be
moved by hand).
1.16 Adjusting parallel running
Note
The parallel running adjustment can only be made when the drive
and glass panel are removed ("0" position).
– Remove sliding/tilting sunroof glass panel drive ⇒ page 185 .
Passat 2011 ➤ , Passat Variant 2011 ➤
General body repairs, exterior - Edition 06.2019
1. Sliding/tilting sunroof with glass panel (Meritor) 187
To Next Page
Loading...
Need help?
General
