1.3.2 Rear wheel housing liner (R36)
Note
The illustrations show the left-hand side. The right side is analogous.
1 - Wheel housing liner
❑ Material: PP/EPDM
❑ Removing and installing
⇒ page 382
2 - Bolt
❑ Qty. 12
❑ Specified torque: 2 Nm
3 - Expansion nut
❑ Gas-tight.
❑ Qty. 3
WARNING
♦Check gas-tight spreader
nuts for damage and re‐
new if necessary.
♦The spreader nut seals
the interior against ex‐
haust gases and must al‐
ways be renewed in the
event of damage.
4 - Speed nut
❑ Qty. 4
5 - Underseal
❑ Seal open body area
with long term under‐
seal - D 003 500- .
❑ Thickness: approx. 1 -
1.5 mm
1.4 Removing and installing front wheel
housing liner
Note
♦
Removal and installation is described for the front left wheel
housing liner only. Removal and installation of the right front
wheel housing liner are similar.
♦
The removal and installation procedures for front wheel hous‐
ing liner may have to be revised slightly depending on model
variations.
Passat 2011 ➤ , Passat Variant 2011 ➤
General body repairs, exterior - Edition 06.2019
380 Rep. gr.66 - Exterior equipment
To Next Page
Loading...
Need help?
General
