14.4 Roof spoiler (estate)
⇒ “14.4.1 Materials”, page 449
⇒ “14.4.2 Assembly overview”, page 449
⇒ “14.4.3 Removing roof spoiler”, page 450
⇒ “14.4.4 Installing roof spoiler”, page 451
⇒ “14.4.5 Removing roof spoiler trim for high-level brake light bulb
M25 ”, page 453
⇒ “14.5 Fitting instructions”, page 454
⇒ “14.6 Preparing add-on parts for bonding”, page 454
⇒ “14.7 Preparing new add-on part for bonding”, page 455
⇒ “14.8 Preparing body component for bonding”, page 455
⇒ “14.9 Fitting instructions”, page 455
⇒ “14.10 Minimum curing period”, page 456
⇒ “14.11 Touching up paint damage”, page 456
⇒ “14.12 Cleaning in the event of dirt caused by adhesive seal‐
ant”, page 456
⇒ “14.13 Cleaning guidelines”, page 456
14.4.1 Materials
Note
For part numbers of materials, see ⇒ Electronic parts catalogue
(ETKA) .
♦ 1-pack window adhesive
1)
2)
3)
4)
5)
♦ Glass and paint primer
1)
5)
♦ Primer applicator
1)
5)
♦ Cleaning solution
1)
5)
♦ Activator
1)
5)
♦ Adhesive remover
1)
5)
♦ Cutting cord
5)
1)
Observe instructions for use on the information sheet provided
by the manufacturer.
2)
Observe minimum curing period
⇒ page 456 .
3)
Heat according to manufacturer's instructions, using cartridge
heater - V.A.G 1939- .
4)
Small cartridge, 180 ml, for sealing and/or when a 400 ml dou‐
ble cartridge alone is not sufficient.
5)
The part numbers of the materials can be found in ⇒ ETKA .
14.4.2 Assembly overview
Passat 2011 ➤ , Passat Variant 2011 ➤
General body repairs, exterior - Edition 06.2019
14. Special add-on parts 449