Volkswagen Passat 2011 User Manual

5.4 Front and rear door covers
5.4.1 Assembly overview - front and rear door mouldings
1 - Front door moulding
❑ Observe installation in‐
structions for bonded
mouldings ⇒ page 413 .
❑ Removing ⇒ page 414
❑ Installing ⇒ page 415
2 - Rear door moulding
❑ Observe installation in‐
structions for bonded
mouldings ⇒ page 413 .
❑ Removing ⇒ page 414
❑ Installing ⇒ page 415
3 - Bolt
❑ Qty. 2 per door mould‐
ing
❑ Specified torque:
1.5 Nm
4 - Locating pin
5 - Adhesive tape
❑ Part of moulding.
6 - Protective sheet
❑ Covers adhesive tape.
5.4.2 Installation instructions for bonded
mouldings
Note
♦ Before removal, heat moulding with hot air blower - V.A.G
1416- .
♦ Adhesive remover - D 002 000 10- must be used exclusively.
♦ Ensure that bonding surfaces are free of dust and grease.
♦ Letterings, films or emblems must be bonded in place imme‐
diately after cleaning.
♦ Remove protective foil immediately before installation.
♦ Working temperature is approx. 21°C.
Passat 2011 ➤ , Passat Variant 2011 ➤
General body repairs, exterior - Edition 06.2019
5. Mouldings and trims 413

Volkswagen Passat 2011 Specifications

General

Brand	Volkswagen
Model	Passat 2011
Category	Automobile
Language	English