Interactive SourceMeter® Instrument Reference Manual Section 4: Source-
2461-901-01 A/November 2015 4-25
Order of operations
The measurements have filtering, relative offset values, math operations, and limit testing applied to
them in a predetermined order. The measurements that are displayed on the front panel and that are
stored in the reading buffers represent the measurements with any selected operations applied to
them.
These operations are applied to the measurement as shown in the following figure.
Figure 156: Model 2461 order of operations
For more information on these operations, see the following topics:
• Filtering measurement data (on page 4-23)
• Relative offset (on page 3-79)
• Calculations that you can apply to measurements (on page 3-82)
• Limit testing and binning (on page 3-134)
Reset default values
When you turn instrument power on and off or send a reset command, many of the settings in the
instrument are reset to their default values.
The settings that are affected are listed in the following tables. The tables show SCPI, TSP, and
front-panel settings for each setting. They are sorted alphabetically by the name of the SCPI
command.
To Next Page
Loading...
Need help?
General
