To Next Page

To Previous Page

Section

6: SCPI command reference Model 2461 Interactive SourceMeter® Instrument

Reference Manual

6-240 2461-901-01 A/November 2015

:TRIGger:TIMer<n>:STARt:OVERrun?

This command indicates if an event was ignored because of the event detector state.

Type Affected by Where saved Default value

Query only

Not applicable

Usage

:TRIGger:TIMer<n>:STARt:OVERrun?

<n>

Trigger timer number (1 to 4)

Details

This command indicates if an event was ignored because the event detector was already in the

detected state when the event occurred.

This is an indication of the state of the event detector built into the timer itself. It does not indicate if

an overrun occurred in any other part of the trigger model or in any other construct that is monitoring

the delay completion event. It also is not an indication of a delay overrun.

This returns 0 if there is no overrun or 1 if there is an overrun.

Example

TRIG:TIM1:STAR:OVER?

Checks the overrun status on trigger timer 1.

Also see

None

:TRIGger:TIMer<n>:STARt:SEConds

This command configures an alarm or a time in the future when the timer will start.

Type Affected by Where saved Default value

Command and query

Recall settings

Instrument reset

Power cycle

Save settings

Usage

:TRIGger:TIMer<n>:STARt:SEConds <time>

:TRIGger:TIMer<n>:STARt:SEConds?

<n>

Trigger timer number (1 to 4)

<time>

The time: 0 to 2,147,483,647 s

Keithley 2461 Reference Manual

Other manuals for Keithley 2461