To Next Page

To Previous Page

Model 2461

Interactive SourceMeter® Instrument Reference Manual Section 6:

SCPI command reference

2461-901-01 A/November 2015 6-241

Details

This command configures the alarm of the timer.

When the timer is enabled, the timer starts immediately if the timer is configured for a start time that

has passed.

Example

TRIG:TIM1:STAR:SEC 60

TRIG:TIM1:START:FRAC 0.5

TRIG:TIM1:STAT ON

Set the timer for 60.5 s.

Enable the trigger timer for timer 1.

Also see

:TRIGger:TIMer<n>:STATe (on page 6-242)

:TRIGger:TIMer<n>:STARt:STIMulus

This command describes the event that starts the trigger timer.

Type Affected by Where saved Default value

Command and query

Recall settings

Instrument reset

Power cycle

Save settings

NONE

Usage

:TRIGger:TIMer<n>:STARt:STIMulus <event>

:TRIGger:TIMer<n>:STARt:STIMulus?

<n>

Trigger timer number (1 to 4)

<event>

The event that starts the trigger timer

Details

Set this attribute any trigger event to start the timer when that event occurs.

Set this attribute to zero (0) to disable event processing and use the timer as a timer or alarm based

on the start time.

Keithley 2461 Reference Manual

Other manuals for Keithley 2461