To Next Page

To Previous Page

Section

6: SCPI command reference Model 2461 Interactive SourceMeter® Instrument

Reference Manual

6-90 2461-901-01 A/November 2015

:SOURce[1]:<function>:DELay:AUTO

This command enables or disables the automatic delay that occurs when the source is turned on.

Type Affected by Where saved Default value

Command and query

Recall settings

Instrument reset

Power cycle

Source configuration list

Save settings

Source configuration list

1 (ON)

Usage

:SOURce[1]:<function>:DELay:AUTO <state>

:SOURce[1]:<function>:DELay:AUTO?

The source function to which this setting applies:

• Current: CURRent

• Voltage:

VOLTage

<state>

Disable the source auto delay: OFF or 0

Enable the source auto delay: ON or 1

Details

When autodelay is turned on, the actual delay that is set depends on the range.

When source autodelay is on, if you set a source delay, the autodelay is turned off.

When source autodelay is on, the manual source delay setting is overwritten with the autodelay

setting.

The delay is applied to the first source output and then only when the magnitude of the source

changes.

Example

SOUR:CURR:DEL:AUTO OFF

Turn off auto delay when current is being

sourced.

Also see

:SOURce[1]:<function>:DELay (on page 6-89)

Keithley 2461 Reference Manual

Other manuals for Keithley 2461