8: TSP command reference Model 2461 Interactive SourceMeter® Instrument
8-48 2461-901-01 A/November 2015
dataqueue.count
This attribute contains the number of items in the data queue.
Type TSP-Link accessible Affected by Where saved Default value
Usage
count = dataqueue.count
The number of items in the data queue
Details
The count is updated as entries are added with dataqueue.add() and read from the data queue
with dataqueue.next(). It is also updated when the data queue is cleared with
dataqueue.clear().
A maximum of dataqueue.CAPACITY items can be stored at any one time in the data queue.
Example
MaxCount = dataqueue.CAPACITY
while dataqueue.count < MaxCount do
dataqueue.add(1)
end
print("There are " .. dataqueue.count
.. " items in the data queue")
dataqueue.clear()
print("There are " .. dataqueue.count
.. " items in the data queue")
This example fills the data queue and prints the
number of items in the queue. It then clears the
queue and prints the number of items again.
Output:
There are 128 items in the data queue
There are 0 items in the data queue
Also see
dataqueue.add() (on page 8-45)
dataqueue.CAPACITY (on page 8-46)
dataqueue.clear() (on page 8-47)
dataqueue.next() (on page 8-48)
Using the data queue for real-time communication (on page 3-158)
dataqueue.next()
This function removes the next entry from the data queue.
Type TSP-Link accessible
Affected by Where saved Default value
Function Yes
Usage
value = dataqueue.next()
value = dataqueue.next(timeout)
The next entry in the data queue
The number of seconds to wait for data in the queue
To Next Page
Loading...
Need help?
General
