Interactive SourceMeter® Instrument Reference Manual Section 6:
2461-901-01 A/November 2015 6-217
Example
Set the LAN trigger mode for event 2 to falling.
Also see
Digital I/O (on page 3-86)
TSP-Link System Expansion Interface (on page 3-150)
:TRIGger:LAN<n>:IN:OVERrun?
This command indicates the overrun status of the LAN event detector.
Type Affected by Where saved Default value
Usage
:TRIGger:LAN<n>:IN:OVERrun?
The LAN event number (1 to 8)
Details
This command indicates whether an event has been ignored because the event detector was already
in the detected state when the event occurred.
This is an indication of the state of the event detector built into the synchronization line itself. It does
not indicate if an overrun occurred in any other part of the trigger model, or in any other construct that
is monitoring the event.
It also is not an indication of an output trigger overrun.
The trigger overrun state for the specified LAN packet is returned as 1 (true) or 0 (false).
Example
Checks the overrun status of a trigger on LAN5
and outputs the value, such as:
Also see
:TRIGger:LAN<n>:IN:CLEar (on page 6-216)
To Next Page
Loading...
Need help?
General
