To Next Page

To Previous Page

Model 2461

Interactive SourceMeter® Instrument Reference Manual Section 6:

SCPI command reference

2461-901-01 A/November 2015 6-219

Details

Sets the IP address for outgoing trigger events.

After you change this setting, you must send the connect command before outgoing messages can

be sent.

Example

TRIG:LAN1:OUT:IP:ADDR "192.0.32.10"

Use IP address

192.0.32.10

to connect the

LAN trigger.

Also see

:TRIGger:LAN<n>:OUT:CONNect:STATe (on page 6-218)

:TRIGger:LAN<n>:OUT:LOGic

This command sets the logic on which the trigger event detector and the output trigger generator operate on the

given trigger line.

Type Affected by Where saved Default value

Command and query

Recall settings

Instrument reset

Power cycle

Save settings

NEG

Usage

:TRIGger:LAN<n>:OUT:LOGic <logicType>

:TRIGger:LAN<n>:OUT:LOGic?

<n>

The LAN event number (1 to 8)

The type of logic:

• POSitive

•

NEGative

Example

TRIG:LAN1:OUT:LOG POS

Set the logic to positive.

Also see

None

Keithley 2461 Reference Manual

Other manuals for Keithley 2461