April 2017
2-290
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
021-401, 021-500
Launch Issue
Status Indicator RAPs
021-401 USB IC Card Reader Connection Error RAP
021-401 USB IC card reader connection status is incorrect.
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Switch off, then switch on the machine, GP 10.
2. Advise the customer to disconnect the USB IC card reader that caused this error to occur
from the USB connector.
021-500 EP Accessory Job Exclusion RAP
021-500 When the fax send billing function is enabled, the errors that follow occurred:
• There was an attempt to start up a job for accessory billing in the middle of a fax send job
operation.
• There was an attempt to start up a Fax send Job in the middle of a Job for accessory bill-
ing operation. This fault is not detected when the fax send billing function is disabled.
Procedure
Advise the customer to wait for the current running job to complete, and then restart the job.
To Next Page
Loading...
Need help?
General
