April 2017
2-451
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
045-382, 045-398, 045-399
Status Indicator RAPs
Launch Issue
045-382, 045-398 Drive PWB NVM (EEPROM) Verify Fail
RAP
BSD-ON: BSD 3.1 PWB Communications (ESS PWB to Drive PWB)
045-382 NVM (EEPROM) write verify error.
041-398 NVM (EEPROM) read verify error.
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Switch off, then switch on the machine, GP 10.
2. Reload the software, GP 4.
3. dC301 NVM Initialization.
4. Install new components as necessary:
•Drive PWB, PL 1.10 Item 3.
• ESS PWB, PL 3.10 Item 6.
045-399 Drive PWB Power Fail RAP
BSD-ON: BSD 3.1 PWB Communications (ESS PWB to Drive PWB)
BSD-ON: BSD 1.4 DC Power Generation (1 of 2)
BSD-ON: BSD 1.5 DC Power Generation (2 of 2)
045-399 Power supply to drive PWB error. The IOT_PWR_ON signal from ESS PWB did not
become active due to an error. This occurs at ESS circuit error, cable open circuit or no +5V
power supply from LVPS.
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Switch off, then switch on the machine, GP 10.
2. Check the items that follow: connections:
• Between the LVPS ( P/J502) and the drive PWB ( P/J400).
• Between the ESS PWB ( P/J1334) and the drive PWB ( P/J401).
3. Check the drive PWB +5V power supply line. If the +5V is not being supplied, install a
new LVPS, PL 1.10 Item 8.
4. Install new components as necessary:
• ESS PWB, PL 3.10 Item 6.
• Drive PWB, PL 1.10 Item 3.
To Next Page
Loading...
Need help?
General
