April 2017
2-518
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
116-397, 116-399
Launch Issue
Status Indicator RAPs
116-397 Illegal Setting Area Coverage Threshold RAP
116-397 The plain total color judge threshold setting is incorrect.
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Switch off, then switch on the machine, GP 10.
2. Enter dC131. Ensure the value of 720-061 is higher than 720-060. Adjust the values as
necessary.
116-399 Initialization RAP
116-399 The machine remains in initializing state even after 10 minutes has passed since it
has started up (not including the startup after power save).
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Switch off, then switch on the machine, GP 10.
2. Ensure that all connectors on the drive PWB, PL 1.10 Item 3 and the ESS PWB, PL 3.10
Item 6 are securely connected. Ensure all surface mounted modules on both PWBs are
securely connected.
3. Reload the software, GP 4.
4. If the fault persists, install a new ESS PWB, PL 3.10 Item 6.
To Next Page
Loading...
Need help?
General
