April 2017
2-305
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
024-362, 024-363, 024-364
Status Indicator RAPs
Launch Issue
024-362, 024-363 Page Sync Illegal Start or Stop RAP
BSD-ON: BSD 3.1 PWB Communications (ESS PWB to Drive PWB)
024-362 Page-sync occurred before video output preparation completes.
024-363 Page-sync completion error during video output.
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Switch off, then switch on the machine, GP 10.
2. Ensure that all connectors on the drive PWB, PL 1.10 Item 3 and the ESS PWB, PL 3.10
Item 6 are securely connected. Ensure all surface mounted modules on both PWBs are
securely connected.
3. Reload the software, GP 4.
4. Perform the OF2 Special Boot Modes RAP.
5. If the fault persists, install new components as necessary:
•Drive PWB, PL 1.10 Item 3.
• ESS PWB,PL 3.10 Item 6.
024-364 DMA Transfer Fail RAP
024-364 DMA transfer error. Reduction/enlargement was not completed even though the spec-
ified data was entered.
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Switch off, then switch on the machine, GP 10.
2. Ensure the connectors on the hard disk are securely connected.
3. Remove, then re-install the SD card, PL 3.10 Item 11. If necessary, install a new memory
card.
4. Format the hard disk drive, refer to dC355 Hard Disk Diagnostics.
5. Reload the software, GP 4.
6. If the fault persists, install a new ESS PWB, PL 3.10 Item 6.
To Next Page
Loading...
Need help?
General
