April 2017
4-79
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
REP 12.17, REP 12.18
Repairs and Adjustments
Launch Issue
8. Remove the stacker motor, Figure 4:
a. Remove three crews (1).
b. Remove the belt (2) from the pulley.
c. Remove the stacker motor (3).
Figure 4 Stacker motor removal
Replacement
1. The replacement is the reverse of the removal procedure.
2. Install the stacker motor as shown in Figure 5.
Figure 5 Stacker motor installation
REP 12.18 Stack Sensor 1 and Stack Sensor 2
Parts List on PL 12.20
Removal
WARNING
Switch off the electricity to the machine. Refer to GP 10. Disconnect the power cord
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Remove the integrated office finisher, REP 12.1.
2. Remove the rear cover, PL 12.05 Item 14.
3. Turn over the integrated office finisher.
4. Remove the tray cover, PL 12.06 Item 3.
5. Remove the stacker sensor assembly, Figure 1:
a. Release the harness from the lamp (1).
b. Remove the screw (2).
c. Remove the stacker sensor assembly (3).
d. Disconnect the sensor connector (4), then remove the sensor from the bracket.
Figure 1 Stacker sensor assembly removal
Replacement
The replacement is the reverse of the removal procedure.
To Next Page
Loading...
Need help?
General
