Xerox VersaLink B7030 Service Manual

April 2017
4-206
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
REP 80.31, REP 80.32
Launch Issue
Repairs and Adjustments
REP 80.31 Tray 4 Upper Feed Chute (TTM)
Parts List on PL 80.70
Removal
WARNING
Switch off the electricity to the machine. Refer to GP 10. Disconnect the power cord
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Remove the tray 4 feeder assembly, REP 80.35.
2. Remove the upper feed chute, Figure 1:
a. Remove two screws (1).
b. Remove the lower feed chute (2).
Figure 1 Upper feed chute removal
Replacement
The replacement is the reverse of the removal procedure.
REP 80.32 Tray 4 Transport Assembly Nip Rolls (TTM)
Parts List on PL 80.70
Removal
WARNING
Switch off the electricity to the machine. Refer to GP 10. Disconnect the power cord
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
CAUTION
Ensure that the tray 4 transport assembly, PL 80.70 Item 11 is supported when removing the
tray 4 assembly.
1. Fully pull out tray 4. Lift out the tray 4 assembly, PL 70.65 Item 1.
2. Remove the tray 4 transport assembly from the tray 4 assembly, Figure 1:
a. Remove two screws (1).
b. Remove the tray 4 transport assembly (2).
Figure 1 Transport assembly removal

Xerox VersaLink B7030 Specifications

General

Brand	Xerox
Model	VersaLink B7030
Category	All in One Printer
Language	English