EasyManuals Logo
Home>Xerox>All in One Printer>VersaLink B7030

Xerox VersaLink B7030 Service Manual

Xerox VersaLink B7030
1341 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #757 background imageLoading...
Page #757 background image
April 2017
4-117
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
REP 13.18, REP 13.19
Repairs and Adjustments
Launch Issue
Replacement
1. The replacement is the reverse of the removal procedure.
2. Ensure the locating pins (1) are correctly engaged, Figure 2.
Figure 2 Crease assembly
3. Perform ADJ 13.2 Finisher LX Booklet Crease/Staple Position.
REP 13.19 Stacker Elevator Motor
Parts List on PL 13.15
Removal
WARNING
Switch off the electricity to the machine. Refer to GP 10. Disconnect the power cord
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Remove the finisher rear upper cover, REP 13.7.
2. Disconnect PJ8988 on the finisher control PWB.
3. Release the harness from the clamps.
4. Remove the wires from the wire guide, remove two screws, then move the wire guide to
one side.
5. Use a 5.5 mm combination wrench to remove both screws from the motor mount.
6. Remove the stacker elevator motor.
Replacement
The replacement is the reverse of the removal procedure.

Table of Contents

Other manuals for Xerox VersaLink B7030

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xerox VersaLink B7030 and is the answer not in the manual?

Xerox VersaLink B7030 Specifications

General IconGeneral
BrandXerox
ModelVersaLink B7030
CategoryAll in One Printer
LanguageEnglish

Related product manuals