April 2017
2-43
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
005-275, 005-280, 005-288
Status Indicator RAPs
Launch Issue
005-275, 005-280 DADF RAM or EEPROM Write Fail RAP
BSD-ON: BSD 3.5 PWB Communications (ESS PWB to DADF)
005-275 RAM failure on the DADF PWB was detected at power on.
005-280 Write failure to the DADF EEPROM or communication failure with EEPROM was
detected.
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Switch off, then switch on the machine, GP 10.
2. If the problem persists, install a new DADF PWB, PL 5.10 Item 11.
005-288 Home Position Sensor Fail RAP
BSD-ON: BSD 5.6 Document Scan, Invert and Exit Transportation
005-288 The invert mechanism failed to return to the home position.
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Refer to the procedures that follow as necessary:
• GP 7 How to Check a Sensor.
• GP 8 How to Check a Solenoid or Clutch.
Perform the steps that follow:
1. Check the operation of the driven link between the cams.
2. Enter dC330, code 005-234. Check the DADF home position sensor, PL 5.35 Item 20.
3. Check the exit nip roll, PL 5.65 Item 17. Enter dC330, code 005-072. Check the exit nip
release solenoid, PL 5.35 Item 8.
4. Enter dC330, code 005-110. Check the DADF registration sensor, PL 5.70 Item 3.
5. If the fault persists, install a new DADF PWB, PL 5.10 Item 11.
To Next Page
Loading...
Need help?
General
