April 2017
4-188
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
REP 80.11, REP 80.12
Launch Issue
Repairs and Adjustments
2. Remove the 3TM takeaway motor, Figure 2:
a. Release the clamp (1).
b. Disconnect the connector (2).
c. Remove four screws (3).
d. Remove the 3TM takeaway motor (4).
Figure 2 3TM takeaway motor removal
Replacement
The replacement is the reverse of the removal procedure.
REP 80.12 Tray 2/3/4 Feed/Retard/Nudger Roll (3TM)
Parts List on PL 80.25
Removal
WARNING
Switch off the electricity to the machine. Refer to GP 10. Disconnect the power cord
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
NOTE: New feed, retard and nudger rolls must be installed at the same time.
1. Pull out trays 2, 3 and 4. Remove the paper.
2. Remove trays 2, 3 and 4.
3. Open the left cover assembly, PL 70.20 Item 11.
4. Remove the tray 2, 3 or 4 feed, retard and nudger rolls, Figure 1:
a. Slide the chute (1) forwards.
b. Release the clip, then remove the tray 2, 3 or 4 feed, retard and nudger rolls (2).
Figure 1 Roll removal
Replacement
1. The replacement is the reverse of the removal procedure.
2. If new rolls are installed, enter dC135 HFSI Counter. Reset the HFSI counters that follow:
• Tray 2 Chain-Link: 954-801
• Tray 3 Chain-Link: 954-802
• Tray 4 Chain-Link: 954-803
To Next Page
Loading...
Need help?
General
