April 2017
4-61
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
REP 12.4, REP 12.5
Repairs and Adjustments
Launch Issue
5. Remove the bracket from the stapler assembly, Figure 2:
a. Remove two screws (1).
b. Remove the bracket (2).
Figure 2 Bracket removal
Replacement
The replacement is the reverse of the removal procedure.
REP 12.5 Set Clamp Home Sensor
Parts List on PL 12.11
Removal
WARNING
Switch off the electricity to the machine. Refer to GP 10. Disconnect the power cord
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Remove the integrated office finisher, REP 12.1.
2. Remove the rear cover, PL 12.05 Item 14.
3. Disconnect the connector, Figure 1:
a. Release the harness from the clamps (1).
b. Disconnect the connector (2).
Figure 1 Connector
To Next Page
Loading...
Need help?
General
