Xerox VersaLink B7030 Service Manual

April 2017
3-9
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
IQ6, IQ7
Imaqe Quality
Launch Issue
2. Use a new ream of paper.
3. If the image quality defect remains, install a new drum cartridge, PL 90.20 Item 1.
NOTE: If the customer is running many high volume jobs, changing NVM values will lower
occurrences of this image quality defect. Before changing the NVMs, inform the customer
that productivity will marginally decrease. Enter dC131, change the NVM values that fol
-
low:
• 751-133 to 2 (mode switch on).
• 751-141 to 7 (number of sheets interval to insert the toner band x 10).
IQ7 Deletions RAP
Part of the image is missing.
Ensure IQ1 Image Quality Entry RAP is performed before starting this RAP.
Initial Actions
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
• If the deletions are small and align with the stripper fingers in the drum cartridge, clean
the stripper fingers. If necessary, install a new drum cartridge, PL 90.20 Item 1.
• If the deletions are small and align with the stripper fingers in the fuser, clean the stripper
fingers. If necessary, install a new fuser, PL 10.05 Item 2.
Procedure
Check the paper type, refer to GP 15. Paper used is within specifications.
YN
Use paper within specifications.
Use a new ream of paper. The image quality defect persists.
YN
Perform SCP 5 Final Actions.
Remove, then reinstall the drum cartridge, PL 90.20 Item 1. Switch off, then switch on the
machine, GP 10. Make a print.
The image quality defect persists.
YN
Perform SCP 5 Final Actions.
Install a new drum cartridge, PL 90.20 Item 1. Switch off, then switch on the machine, GP 10.
Make a print.
The image quality defect persists.
YN
Perform SCP 5 Final Actions.
Check the surface of the BTR for distortion. The surface of the BTR is good.
YN
Install a new BTR assembly, PL 90.15 Item 4.
Install new components as necessary:
• Drive PWB, PL 1.10 Item 3.
• ESS PWB, PL 3.10 Item 6.

Xerox VersaLink B7030 Specifications

General

Brand	Xerox
Model	VersaLink B7030
Category	All in One Printer
Language	English