April 2017
4-18
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
REP 3.2
Launch Issue
Repairs and Adjustments
REP 3.2 ESS PWB Chassis Assembly
Parts List on PL 3.10
Removal
WARNING
Switch off the electricity to the machine. Refer to GP 10. Disconnect the power cord
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Figure 1 ESD Symbol
CAUTION
Observe ESD procedures during this procedure.
CAUTION
Do not touch the battery. Do not peel off the protective tape.
1. Remove the upper rear cover, REP 28.5.
2. Remove the lower rear cover, REP 28.6.
3. Remove the RH top cover, PL 28.06 Item 2.
4. Remove the RH rear cover, PL 28.06 Item 3.
5. If the machine has an HDD assembly installed, remove the HDD assembly, Figure 2:
a. Disconnect the connectors (1).
b. Remove the HDD assembly (2).
Figure 2 HDD removal
6. If the machine had an HDD assembly installed, remove both screws (1), then the HDD
bracket (2), Figure 3.
Figure 3 HDD bracket removal
To Next Page
Loading...
Need help?
General
