April 2017
2-508
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
116-334, 116-340
Launch Issue
Status Indicator RAPs
116-334 ESS NVRAM Data Compare Fail
116-334 ESS NVRAM data compare fail.
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Switch off, then switch on the machine, GP 10.
2. Enter dC125 Faults. If another 124-3XX fault code is displayed, perform the relevant
RAP.
3. Ensure that all connectors on the drive PWB, PL 1.10 Item 3 and the ESS PWB, PL 3.10
Item 6 are securely connected. Ensure all surface mounted modules on both PWBs are
securely connected.
4. Reload the software, GP 4.
5. Perform the OF2 Special Boot Modes RAP.
116-340 Not Enough Memory RAP
116-340 Insufficient memory was detected during initialization. A PS option requiring an addi-
tional memory was installed but memory was not added.
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Switch off, then switch on the machine, GP 10.
To Next Page
Loading...
Need help?
General
