April 2017
2-534
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
117-317, 117-318, 117-319
Launch Issue
Status Indicator RAPs
117-317, 117-318 Contract Manager PPP RAP
117-317 The contract manager detected that the PPP contract has ended.
117-318 The contract manager detected that the DC command write that was performed at the
end of a PPP contract has failed.
Procedure
Advise the customer to wait for the machine to reboot.
117-319 SD Card Program or Font Data Access RAP
117-319 SD card program or font data access fail.
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Switch off, then switch on the machine, GP 10.
2. Ensure the SD card, PL 3.10 Item 11 is correctly installed. Also, ensure that the write pro-
tection switch, to the left of the SD card, is not enabled. If the installation of the SD card
and the write protection switch setting are good, advise the customer to rewrite the pro
-
gram and font data into the SD Card. If the problem persists after the rewrite, install a new
SD card, PL PL 3.10 Item 11.
3. Ensure that all connectors on the drive PWB, PL 1.10 Item 3 and the ESS PWB, PL 3.10
Item 6 are securely connected. Ensure all surface mounted modules on both PWBs are
securely connected.
4. Reload the software, GP 4.
5. Perform the OF2 Special Boot Modes RAP.
To Next Page
Loading...
Need help?
General
