April 2017
2-325
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
024-952, 024-953
Status Indicator RAPs
Launch Issue
024-952 Tray 3 Empty RAP
BSD-ON: BSD 7.11 Tray 3 Paper Stacking (3TM)
BSD-ON: BSD 7.20 Tray 3 Paper Stacking (TTM)
024-952 Tray 3 is empty.
Initial Actions
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Switch off, then switch on the machine, GP 10.
Procedure
Enter dC330, code 073-101, tray 3 no paper sensor. Manually actuate the tray 3 no paper sen-
sor, PL 80.20 Item 6. The display changes.
YN
Check the tray 3 no paper sensor. Refer to GP 7 How to Check a Sensor.
Perform the 073-210 Tray 3 Lift Fail RAP. Check the tray 3 feed/lift motor. If the fault persists,
install new components as necessary:
• Tray 3 no paper sensor, PL 80.20 Item 6.
• 3TM PWB, PL 70.23 Item 5.
• TTM PWB, PL 70.90 Item 1
024-953 Tray 4 Empty RAP
BSD-ON: BSD 7.12 Tray 4 Paper Stacking (3TM)
BSD-ON: BSD 7.21 Tray 4 Paper Stacking (TTM)
024-953 Tray 4 is empty.
Initial Actions
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Switch off, then switch on the machine, GP 10.
Procedure
Enter dC330, code 074-101, tray 4 no paper sensor. Manually actuate the tray 4 no paper sen-
sor, PL 80.20 Item 6. The display changes.
YN
Check the tray 4 no paper sensor. Refer to GP 7 How to Check a Sensor.
Perform the 074-210 Tray 4 Lift Fail RAP. Check the tray 4 feed/lift motor. If the fault persists,
install new components as necessary:
• Tray 4 no paper sensor, PL 80.20 Item 6.
•3TM PWB, PL 70.23 Item 5.
• TTM PWB, PL 70.90 Item 1.
To Next Page
Loading...
Need help?
General
