April 2017
2-456
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
057-316, 057-317
Launch Issue
Status Indicator RAPs
057-316 Drive PWB F16 Blown RAP
BSD-ON: BSD 1.10 Power Interlock Switching (3 of 3)
057-316 Drive PWB fuse 16 open circuit was detected.
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Check the components that follow for overcurrent and overvoltage. Repair the wiring or
install new components as necessary:
• Takeaway clutch, PL 40.10 Item 5.
• Bypass tray feed clutch, PL 70.40 Item 4.
• Registration clutch, PL 80.55 Item 11.
• Marking fan, PL 40.15 Item 8.
• Exit 1 offset solenoid, PL 10.15 Item 11.
• Duplex clutch, PL 80.50 Item 28.
2. After the faulty circuit has been repaired, install a new drive PWB, PL 1.10 Item 3.
057-317 Drive PWB F17 Blown RAP
BSD-ON: BSD 1.10 Power Interlock Switching (3 of 3)
057-317 Drive PWB fuse 17 open circuit was detected.
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Check the components that follow for overcurrent and overvoltage. Repair the wiring or
install a new exit gate solenoid, PL 10.22 Item 9 as necessary.
2. After the faulty circuit has been repaired, install a new drive PWB, PL 1.10 Item 3.
To Next Page
Loading...
Need help?
General
