Panasonic KX-NS500 Pc Programming Manual

DTMF-R STD Detection Time
Specifies the minimum length that a DTMF tone must be for the PBX to recognise it as a DTMF tone.
Value Range
2 ´ n (n=1–31) ms
Maintenance Console Location
9.21 PBX Configuration—[1-1] Configuration—Slot—Extension—Card Property
SLT Power Supply
Selects the voltage that enables an SLT to activate the Message Waiting lamp. When an MCSLC card is
installed, the value for this setting is fixed at "85 V".
Value Range
85 V, 145 V
Maintenance Console Location
9.21 PBX Configuration—[1-1] Configuration—Slot—Extension—Card Property
Feature Guide References
2.20.1 Message Waiting
APT/SLT Parallel Connection
Enables an SLT connected in parallel to an APT to ring with the APT for calls.
Value Range
Disable, Enable
Maintenance Console Location
9.21 PBX Configuration—[1-1] Configuration—Slot—Extension—Card Property
Feature Guide References
2.11.10 Parallelled Telephone
Ringing Start Mode of Extension Caller ID
Specifies the Ringing Start Mode of Extension Caller ID. Please consult your certified Panasonic dealer for
more information.
Value Range
Mode 1: With Pre-ring signal
Mode 2: Without Pre-ring signal
PC Programming Manual 351
9.21 PBX Configuration—[1-1] Configuration—Slot—Extension—Card Property

Panasonic KX-NS500 Specifications

General

Analog Extensions	Up to 64
VoIP Support	Yes
System Type	Hybrid IP-PBX
Power Supply	AC 100-240V, 50/60Hz
Operating Temperature	0°C to 40°C
Humidity	10% to 90% (non-condensing)
Maximum Extensions	288
IP Extensions	128
VoIP Channels	64
SIP Trunks	64
Networking	Yes, supports networking
Built-in Applications	Call Center
Expandability	Yes, via expansion cards and cabinets
Supported Protocols	SIP, H.323, MGCP
Dimensions	430 x 88 x 367 mm