16.1 PBX Configuration—[8-1] ARS—System Setting
Automatic Route Selection (ARS) automatically selects the appropriate carrier at the time a trunk call is made,
according to the programmed settings. The user-dialled number will be checked and modified in order to
connect it to the appropriate carrier.
ARS Mode
Selects the condition to determine when to operate ARS.
Value Range
Off: ARS is disabled.
On for Local Access Operation: ARS operates when an extension user makes a call using Idle Line Access
method.
On for Any CO Access Operation: ARS operates when an extension user makes a call using Idle Line Access,
Trunk Access, or S-CO Line Access method.
Maintenance Console Location
16.1 PBX Configuration—[8-1] ARS—System Setting
Feature Guide References
2.5.5.3 Trunk Access
2.8.1 Automatic Route Selection (ARS)
Mode When Any Carrier is not programmed for the Dial
Selects what happens when the dialled number is not found in Leading Number in 16.2 PBX
Configuration—[8-2] ARS—Leading Number.
Value Range
Disconnect: the line will be disconnected.
Local Access: the dialled number will be handled by Idle Line Access method.
Maintenance Console Location
16.1 PBX Configuration—[8-1] ARS—System Setting
Feature Guide References
2.8.1 Automatic Route Selection (ARS)
788 PC Programming Manual
16.1 PBX Configuration—[8-1] ARS—System Setting
To Next Page
Loading...
Need help?
General
