17.4 PBX Configuration—[9-4] Private
Network—NDSS Key Table
Extensions at up to 7 other PBXs that will be monitored using Network Direct Station Selection (NDSS) can
be registered. A maximum of 250 extensions can be registered. To create an NDSS button to monitor an
extension, the extension must be registered here first.
To clear NDSS link data, click the NDSS Clear button. The NDSS Clear button can be used only in On-line
mode.
Note that the parameters on this screen can only be set when the Network Data Transmission for Centralised
Operator Feature—Network PBX ID is set to 1 in the 17.2 PBX Configuration—[9-2] Private
Network—Network Data Transmission screen.
Network Extension No.
Specifies the number of the remote extension (attached to another PBX) that will be monitored. The number
input here can use either Extension Number Method or PBX Code Method.
Value Range
Max. 16 digits (consisting of 0–9, *, and #)
Maintenance Console Location
17.4 PBX Configuration—[9-4] Private Network—NDSS Key Table
Feature Guide References
4.1 Public Network Features—4.2.1 TIE Line Service
4.2.5.1 Network Direct Station Selection (NDSS)
Network Extension Name for Programming Reference
Specifies the name of the network extension. This name is only shown here, not on the displays of extensions.
Value Range
Max. 20 characters
Maintenance Console Location
17.4 PBX Configuration—[9-4] Private Network—NDSS Key Table
Feature Guide References
4.2.5.1 Network Direct Station Selection (NDSS)
Network PBX ID of Network Extension to be monitored
Indicates the
Network Data Transmission for Centralised Operator Feature—Network PBX ID of the PBX
that the extension is connected to (reference only).
Value Range
None, 1–8
PC Programming Manual 807
17.4 PBX Configuration—[9-4] Private Network—NDSS Key Table
To Next Page
Loading...
Need help?
General
