23.1 UM Configuration—[4-1] Service
Settings—Caller ID / PIN Call Routing
A maximum of 200 Caller ID/PIN numbers can be assigned so that callers are automatically forwarded to a
pre-programmed destination. A different destination can be set for each time mode (day, night, lunch, break).
For Mode, select Caller-ID Mode or PIN Mode from the drop-down list, and then click the button to assign
a routing destination. PIN Call Routing is only available when the Call Transfer Anytime of a Custom
Service is set to "PIN".
Wild card input for Caller IDs/PINs
• The wild card, " ", can be used as a substitute for any numbers in the following ways.
1. When Caller ID/PIN numbers include one " ":
" " matches any number, regardless of the actual numbers of digits. For example, registering " " by
itself matches all numbers, and registering "201 " matches any number that starts with "201".
2. When Caller ID/PIN numbers include more than one " ":
Each " " matches a single digit. For example, registering " " matches any 10-digit
number, and registering "201 " matches any 10-digit number that starts with "201".
Note
• If Automatic Login or Holiday Service is used, these will take priority over Caller ID Call Routing settings.
Also note that Caller ID Call Routing takes priority over the Trunk Service and Port Service.
• Received Caller ID/PIN numbers are searched for in each service setting table in order from the first
registered number to last. When programming Caller ID/PIN routing, note the order of registration, and
remember that wild card entries should be entered after any specific routing entries.
Caller-ID Mode
Caller ID No. (Selection)
Specifies the Caller ID number setting so that callers are automatically forwarded to a pre-programmed
destination.
Value Range
Private, Out of Area, Long Distance, Others
Maintenance Console Location
23.1 UM Configuration—[4-1] Service Settings—Caller ID / PIN Call Routing
Feature Guide References
3.2.1.8 Caller ID Call Routing
Caller ID No. (Other)
Specifies a Caller ID number (or range of numbers using the wild card, " ") for callers from a specific number
or range of numbers that are to be automatically forwarded to a pre-programmed destination. Only specified
if Caller ID No. (Selection) is set to "Others".
Value Range
0–9,
(Max. 20 digits)
910 PC Programming Manual
23.1 UM Configuration—[4-1] Service Settings—Caller ID / PIN Call Routing
To Next Page
Loading...
Need help?
General
