12.1.1.1 PBX Configuration—[4-1-1] Extension—Wired
Extension—Extension Settings—CLIP Generate
CLIP Generate allows the CLIP numbers for a set of locations in series to be programmed together.
Pre-assigned CLIP numbers for those locations will be overwritten.
If a number generated here is longer than 16 digits, the additional digits will be discarded.
Location Entry—Beginning Entry Location (Ext. Number)
Specifies the extension number of the first location to be programmed.
Value Range
Wired extension number
Maintenance Console Location
12.1.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings—CLIP Generate
PC Programming Manual References
12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings
Feature Guide References
4.1.2.2 Calling/Connected Line Identification Presentation (CLIP/COLP)
Location Entry—Number to Generate
Specifies the number of locations to be programmed.
A CLIP number will only be assigned to connected wired extensions, even if the number entered here is larger
than the total number of wired extensions.
Value Range
1–total number of connected wired extensions
Maintenance Console Location
12.1.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings—CLIP Generate
PC Programming Manual References
12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings
Feature Guide References
4.1.2.2 Calling/Connected Line Identification Presentation (CLIP/COLP)
Parameter—Deleting Digits
Specifies the number of digits to be deleted from the start of an extension number when using it as part of the
CLIP number.
PC Programming Manual 659
12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings
To Next Page
Loading...
Need help?
General
