18.3 PBX Configuration—[10-3] CO & Incoming
Call—DDI / DID Table
Incoming trunk calls with DDI/DID numbers can be distributed to specific destinations. Each DDI/DID number
has a destination programmed for each time mode (day/lunch/break/night).
When CLI distribution is enabled for a DDI/DID number, incoming trunk calls with that DDI/DID number will be
distributed to the CLI destinations (instead of the DDI/DID destinations) if the caller’s identification number is
found in the System Speed Dialling Table, which is used as the Caller ID Table. CLI distribution can be enabled
or disabled for each time mode (day/lunch/break/night) on a DDI/DID number basis.
A maximum of 1000 DDI/DID numbers can be programmed with other related parameters. 100 numbers are
displayed at a time. To display other sets of numbers, click the applicable tab.
To assign DDI/DID destination numbers, enter directly or click Destination Setting (see 2.1.6 Extension
Number Setting). It is possible to programme DDI/DID numbers and DDI/DID destinations in each time mode
(day/lunch/break/night) for a set of locations in series at once by clicking Automatic Registration, or to
programme DDI/DID names for a set of locations in series at once by clicking Name Generate.
DDI / DID Number
Specifies the DDI/DID number.
Value Range
Max. 32 digits (consisting of 0–9, *, and #)
Maintenance Console Location
18.3 PBX Configuration—[10-3] CO & Incoming Call—DDI / DID Table
PC Programming Manual References
18.3.1 PBX Configuration—[10-3] CO & Incoming Call—DDI / DID Table—Automatic Registration
Feature Guide References
2.1.1.3 Direct Inward Dialling (DID)/Direct Dialling In (DDI)
DDI / DID Name
Specifies the name for the DDI/DID number which is shown on the extension’s display when receiving a call
with the DDI/DID number. The name of the DDI/DID number can be printed out on SMDR.
Value Range
Max. 20 characters
Maintenance Console Location
18.3 PBX Configuration—[10-3] CO & Incoming Call—DDI / DID Table
PC Programming Manual References
18.3.2 PBX Configuration—[10-3] CO & Incoming Call—DDI / DID Table—Name Generate
19.1 PBX Configuration—[11-1] Maintenance—Main—SMDR Options— Option—DDI/DID Number & Name
PC Programming Manual 819
18.3 PBX Configuration—[10-3] CO & Incoming Call—DDI / DID Table
To Next Page
Loading...
Need help?
General
