11.7 PBX Configuration—[3-7] Group—UM Group
11.7.1 PBX Configuration—[3-7-1] Group—UM Group—System
Settings
The Unified Messaging (UM) ports of a PBX make up a group, called a UM group. This group has a floating
extension number, which can be the destination for incoming calls, redirected calls, transferred calls, etc. When
a call is received at the UM group, the Unified Messaging system can direct the caller to leave a voice message
or dial a number to reach the desired party.
Call Waiting on UM Group
Enables the queuing of calls when all extension ports of the UM group are busy. (Call Waiting tone is not sent
to any UM port.)
Value Range
Disable, Enable
Maintenance Console Location
11.7.1 PBX Configuration—[3-7-1] Group—UM Group—System Settings
PC Programming Manual References
9.6 PBX Configuration—[1-1] Configuration—Slot—UM Port Property
Feature Guide References
2.2.2.4 Queuing Feature
3.1.1 Unified Messaging System Overview—UM Ports and the UM Group
Intercept to Mailbox for Call to Extension
Enables the PBX to send the mailbox number of the called extension to the Unified Messaging system when
a call is redirected to the UM group by Intercept Routing. When the Unified Messaging system receives the
mailbox number, the Unified Messaging system answers the call with the appropriate mailbox.
Value Range
Disable, Enable
Maintenance Console Location
11.7.1 PBX Configuration—[3-7-1] Group—UM Group—System Settings
PC Programming Manual References
9.6 PBX Configuration—[1-1] Configuration—Slot—UM Port Property
12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings—Intercept
Destination— Intercept Destination—When called party does not answer—Day, Lunch, Break, Night
602 PC Programming Manual
11.7.1 PBX Configuration—[3-7-1] Group—UM Group—System Settings
To Next Page
Loading...
Need help?
General
