Value Range
Max. 4 digits (consisting of 0–9, *, and #)
Maintenance Console Location
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main
PC Programming Manual References
13.3.2 PBX Configuration—[5-3-2] Optional Device—Voice Message—DISA Message
10.7.1 PBX Configuration—[2-7-1] System—Class of Service—COS Settings—Manager— Manager
Feature Guide References
2.30.2 Outgoing Message (OGM)
Single CO Line Access
Specifies the feature number used to make a trunk call using a certain trunk.
Value Range
Max. 4 digits (consisting of 0–9, *, and #)
Maintenance Console Location
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main
PC Programming Manual References
18.1 PBX Configuration—[10-1] CO & Incoming Call—CO Line Settings
Feature Guide References
2.5.5.3 Trunk Access
Parallel Telephone (Ring) Mode Set / Cancel
Specifies the feature number used to set or cancel an SLT connected in parallel with a DPT to ring when
receiving an incoming call.
Note
This feature is restricted to extensions connected Expansion Units. For information about connecting SLTs
and DPTs in parallel, refer to 2.11.10 Parallelled Telephone in the Feature Guide.
Value Range
Max. 4 digits (consisting of 0–9, *, and #)
Feature Guide References
2.11.10 Parallelled Telephone
PC Programming Manual 465
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main
To Next Page
Loading...
Need help?
General
