10.4 PBX Configuration—[2-4] System—Week Table
A specific time mode (day, night, lunch, or break) can be selected for operation depending on the time of day.
The time mode can be switched either automatically or manually. Select the desired switching mode from the
Time Service Switching Mode option.
Time Table numbers correspond to tenant numbers (for example, Tenant 1 uses Time Table 1). Select the
desired Time Table from the Time Table No. list.
When in Automatic Switching mode, the time modes of the tenant are switched as programmed in the
corresponding Time Table. Manual switching is possible only from an authorised extension (determined by
COS).
• To adjust the currently displayed Time Table, click and drag the divisions between two time periods.
• To programme the time blocks of the currently displayed Time Table, including adding or deleting time
blocks, click Time Setting.
10.4.1 PBX Configuration—[2-4] System—Week Table—Time
Setting
The start times of 4 different time blocks can be programmed for each day of the week, for the selected Time
Table, as well as the start and end times of up to 3 break periods.
1. Day/Lunch/Night—Day1 Start, Lunch Start, Day2 Start, Night Start—Setting
Enables the setting of the start time for each time block.
Value Range
Disable, Enable
Maintenance Console Location
10.4.1 PBX Configuration—[2-4] System—Week Table—Time Setting
Feature Guide References
5.1.3 Tenant Service
5.1.4 Time Service
1. Day/Lunch/Night—Day1 Start, Lunch Start, Day2 Start, Night Start—Hour,
Minute
Specifies the start time for each time block. Times can only be set when 1. Day/Lunch/Night—Day1 Start,
Lunch Start, Day2 Start, Night Start—Setting is set to Enable.
Value Range
00:00–23:59
Maintenance Console Location
10.4.1 PBX Configuration—[2-4] System—Week Table—Time Setting
454 PC Programming Manual
10.4.1 PBX Configuration—[2-4] System—Week Table—Time Setting
To Next Page
Loading...
Need help?
General
