16.2 PBX Configuration—[8-2] ARS—Leading
Number
Specifies the area codes and/or telephone numbers as leading numbers that will be routed by the ARS feature.
A maximum of 1000 different leading numbers can be programmed, and each leading number can select a
Routing Plan Table number, which determines the ARS procedure.
The additional (remaining) number of digits can also be specified for each leading number. The additional
(remaining) number of digits must be specified only when "#", for example, is needed after the dialled number.
The "#" will be added after the programmed number of digits of the user-dialled number (excluding the leading
number).
100 leading numbers are displayed at a time. To display other sets of leading numbers, click the applicable
tab.
Leading Number
Specifies the leading number.
Value Range
Max. 16 digits (consisting of 0–9, *, #, and X)
Maintenance Console Location
16.2 PBX Configuration—[8-2] ARS—Leading Number
Feature Guide References
2.8.1 Automatic Route Selection (ARS)
Additional Number of Digits
Specifies the additional (remaining) number of digits following each leading number.
Value Range
0–15
Maintenance Console Location
16.2 PBX Configuration—[8-2] ARS—Leading Number
Feature Guide References
2.8.1 Automatic Route Selection (ARS)
Routing Plan Number
Specifies the Routing Plan Table number used for each leading number.
Value Range
1–48
PC Programming Manual 789
16.2 PBX Configuration—[8-2] ARS—Leading Number
To Next Page
Loading...
Need help?
General
