Extension Number
Specifies the extension number of the port.
Value Range
Max. 5 digits (consisting of 0–9)
Maintenance Console Location
9.22 PBX Configuration—[1-1] Configuration—Slot—Extension—Port Property
Extension Name
Specifies the extension name of the port.
Value Range
Max. 20 characters
Maintenance Console Location
9.22 PBX Configuration—[1-1] Configuration—Slot—Extension—Port Property
XDP Mode
Turns XDP mode on or off for the port. This setting is only available when Port Type on this screen is set to
S-Hybrid.
Value Range
On: XDP enabled (The main telephone and sub telephone have different extension numbers. This is called
XDP Mode.)
Off: XDP disabled (The main telephone and sub telephone both have the main telephone’s extension number.
This is called Parallel Mode.)
Maintenance Console Location
9.22 PBX Configuration—[1-1] Configuration—Slot—Extension—Port Property
Feature Guide References
2.11.10 Parallelled Telephone
5.2.6 Extension Port Configuration
Parallel Telephone Ringing
Specifies whether the sub telephone (SLT) rings at the same time as the main telephone (DPT) for an incoming
call. This setting is only available when Port Type on this screen is set to S-Hybrid.
Value Range
Yes, No
Maintenance Console Location
9.22 PBX Configuration—[1-1] Configuration—Slot—Extension—Port Property
354 PC Programming Manual
9.22 PBX Configuration—[1-1] Configuration—Slot—Extension—Port Property
To Next Page
Loading...
Need help?
General
