9.23 PBX Configuration—[1-1]
Configuration—Slot—Card Property - LCO type
The properties of the analogue trunk cards can be specified.
Outgoing Guard Time
Specifies the length of time after a trunk is disconnected, during which the PBX cannot seize the line.
Value Range
3–6 s
Maintenance Console Location
9.23 PBX Configuration—[1-1] Configuration—Slot—Card Property - LCO type
First Dial Timer (CO)
Specifies the minimum time that the PBX waits after seizing a trunk, before sending the dialled digits to the
telephone company. This allows the telephone company to have enough time to accept the dialled digits
correctly.
Value Range
0.5 ´ n (n=1–16) s
Maintenance Console Location
9.23 PBX Configuration—[1-1] Configuration—Slot—Card Property - LCO type
CO Feed Back Tone
Specifies whether the pulse feedback tone is turned on or not. For outgoing trunk calls, audible tones can be
heard as the dialled number is sent out, which informs the extension user that the number has been dialled.
Value Range
No, Yes
Maintenance Console Location
9.23 PBX Configuration—[1-1] Configuration—Slot—Card Property - LCO type
Bell Detection—Bell Start Detection Timer
Specifies the minimum length of a bell signal that can be recognised by the PBX as the bell signal sent from
the telephone company, before the PBX detects an arriving call.
Value Range
24 ´ n (n=1–50) ms
358 PC Programming Manual
9.23 PBX Configuration—[1-1] Configuration—Slot—Card Property - LCO type
To Next Page
Loading...
Need help?
General
