Flexible Button Programming Mode
Specifies whether the extension user can modify all flexible buttons without limitation, or only the One-touch
Dialling buttons. When the mode is set to One-touch Dial, there is no need to enter "2" before the number
when customising a One-touch Dialling button.
Value Range
No Limitation, One-touch Dial
Maintenance Console Location
12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings
ICM Tone
Selects the ring tone for incoming calls arriving at the INTERCOM button or PDN buttons. Note that the ring
tone specified here is applied to all PDN buttons on an extension.
Value Range
IP-PT (except KX-NT265/KX-NT321): 1–30
KX-NT265/KX-NT321: 1–8 (Even if ring tone 9–30 is selected, ring tone 1 is heard.)
Other telephones: 1–8 (Even if ring tone 9–30 is selected, ring tone 2 is heard.)
Maintenance Console Location
12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings
Display Lock/SVM Lock
Locks or unlocks the Incoming Call Log display (i.e., specifies whether other extension users can see the
Incoming Call Log information at the extension).
Value Range
Unlock, Lock
Maintenance Console Location
12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings
Feature Guide References
2.19.2 Incoming Call Log
Paging Deny
Specifies whether paging of the extension from other extensions is enabled.
Value Range
Disable, Enable
Maintenance Console Location
12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings
PC Programming Manual 649
12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings
To Next Page
Loading...
Need help?
General
